On the other hand, safety accidents can be avoided.

一、超声波清洗机使用注意事项

1、 Precautions for use of ultrasonic cleaning machine

1、清洗机应放置在清洁、干燥以及无强腐蚀气体和环境中使用，并避免剧烈震动。

1. The cleaning machine should be placed in a clean, dry environment without strong corrosive gas and avoid violent vibration.

2、发生器背面应留有足够的散热空间。

2. Sufficient heat dissipation space shall be reserved at the back of the generator.

3、确保机器有良好的接地，以避免人身伤害事故。

3. Ensure that the machine is well grounded to avoid personal injury.

4、清洗机工作时，不要将手指浸入清洗液中。

4. Do not immerse your fingers in the cleaning liquid when the cleaning machine is working.

5、严禁空载状态下开机，开机前按使用说明的液位将清洗液倒入清洗槽内。

5. It is forbidden to start the machine under no-load condition. Before starting the machine, pour the cleaning liquid into the cleaning tank according to the liquid level specified in the instructions.

6、被清洗物不得和槽底接触，建议将工件放入篮筐中清洗。

6. The object to be cleaned shall not contact with the bottom of the tank. It is recommended to put the workpiece into the basket for cleaning.

7、清洗液不得呈强酸或强碱性，在没有可靠的措施条件下，不能使用易燃溶液。

7. The cleaning solution shall not be strong acid or strong alkaline. Flammable solution shall not be used without reliable safety measures.

8、清洗液温度会随连续工作时间而升高，清洗机连续工作时间建议不要超过8小时。

8. The temperature of the cleaning liquid will rise with the continuous working time. It is recommended that the continuous working time of the cleaning machine should not exceed 8 hours.

9、如发现清洗槽有漏水现象，应立即关机停用，并倒空清洗液后与销售商联系。

9. In case of water leakage in the cleaning tank, shut down the machine immediately and contact the seller after emptying the cleaning solution.

10、不允许擅自拆开机器。

10. Do not disassemble the machine without permission.

11、对有加热装置的清洗机在清洗完毕后，先关闭加热器待清洗液冷却后再放空清 洗液。

11. For the cleaning machine with heating device, after cleaning, turn off the heater first and then vent the cleaning liquid after the cleaning liquid is cooled.

二、超声波清洗机正常工作步骤

2、 Normal working steps of ultrasonic cleaning machine

1、检查电源是否正常,开关是否正常,指示灯、指示表是否正常，保证清洗槽干净。

1. Check whether the power supply is normal, whether the switch is normal, whether the indicator light and indicator meter are normal, and ensure that the cleaning tank is clean.

2、放入清洗液,方可打开工作电源,观察电流指示表的读数是否在80-100之间,清洗液温度在40-60℃之间,同时水槽会出现微小气泡并伴随有“吱，吱”的声响,这表示开始正常清洗。

2. After the cleaning liquid is put in, the working power can be turned on. Observe whether the reading of the current indicator is between 80-100 ° C and the temperature of the cleaning liquid is between 40-60 ° C. at the same time, small bubbles will appear in the water tank with the sound of "squeak, squeak", which means that the normal cleaning is started.

3、在超声波清洗过程中戴上绝缘手套。

3. Wear insulating gloves during ultrasonic cleaning.

4、清洗物件不能直接放置在缸底，以免影响清洗效果,应放在专用清洗篮内或采用零装方法。

4. The cleaning objects shall not be directly placed at the bottom of the cylinder to avoid affecting the cleaning effect. Instead, they shall be placed in the special cleaning basket or the zero packing method shall be adopted.

5、缸内无清洗液时切勿开机,以免损坏换能器。

5. Do not start the machine when there is no cleaning fluid in the cylinder to avoid damaging the transducer.

6、长期不使用时,机器应保存在干燥处。

6. When not used for a long time, the machine should be stored in a dry place.

7、把工件料盘放入超声波清洗槽中,进行液体清洗。

7. Put the workpiece tray into the ultrasonic cleaning tank for liquid cleaning.

8、工作时间按工件需求去设置。

8. The working time is set according to the requirements of the workpiece.

9、防止工件在清洗过程中划伤表面及丢失,保证工件数量的完整。

9. Prevent the workpiece from scratching the surface and losing during cleaning, and ensure the integrity of the number of workpieces.

10、清洗完成后,切断工作电源,防止事故的发生。

10. After cleaning, cut off the power supply to prevent accidents.

11、取出工件料盘,做好下道工序的工作。

11. Take out the workpiece tray and do a good job in the next process.

以上是为大家介绍的有关超声波清洗机的详细的介绍,希望对您有所帮助.如果您有什么疑问的话,欢迎联系我们.我们将以的态度,为您提供服务http://www.sinokohl.com

The above is the detailed introduction about the price of ultrasonic cleaning machine. I hope it will help you. If you have any questions, please contact us. We will provide you with services with a professional attitude http://www.sinokohl.com