服务热线电话
400-6188-756
碳氢清洗设备环境对于环境的使用要求!
来源:http://www.sinokohl.com/ 时间: 2022-12-03 浏览次数: 0
1.使用温度不得超过40。
1. The operating temperature shall not exceed 40.
2.设备周围湿度75%,不能太干。
2. The humidity around the equipment shall be 75%, and it shall not be too dry.
3.保持清洁室的空气流通。(如果没有空气流通,通风系统每小时2万立方米以上)
3. Keep the clean room ventilated. (If there is no air circulation, the ventilation system is more than 20000 cubic meters per hour)
4.碳氢化合物清洗机设备的排气系统需要与室外连接。(排气系统每小时2200立方米)
4. The exhaust system of hydrocarbon washer equipment needs to be connected to the outdoor. (2200 m3/h for exhaust system)
5.防爆照明灯应设置在设备布置范围内5.防爆电器。


5. Explosion proof lamps shall be set within the equipment layout. 5. Explosion proof electrical appliances.
6.设备严禁在阳光下爆炸,以免温度升高,造成安全危险。
6. It is strictly forbidden to explode the equipment in the sun to avoid the safety hazard caused by temperature rise.
7.严禁在设备周围5米内燃放烟花.引火作业及粉尘。
7. Fireworks, ignition and dust are prohibited within 5 meters around the equipment.
8.用户应直接离设备1(1)直接安装电源(设备电源箱).空气保护开关安装在距离地面1.6米以上的地方。(设备检修时切断电源方便使用)如果有专门的主电源柜,现场必须距离设备5米。
8. The user shall directly install the power supply (equipment power box) 1 (1) away from the equipment. The air protection switch shall be installed 1.6 meters above the ground. (Cut off the power supply for easy use during equipment maintenance) If there is a special main power cabinet, the site must be 5 meters away from the equipment.
9.冷水机组应设置在清洗设备旁边3-5米之间,并安装排气管装置。(排气量为每小时2万立方米)
9. The chiller shall be set 3-5 meters away from the cleaning equipment, and the exhaust pipe device shall be installed. (The air displacement is 20000 cubic meters per hour)
上一篇:四槽超声波清洗机的使用特点
下一篇:超声波清洗机在行业内中凸显了优势!
相关文章
-
碳氢清洗机清洗流程详解:多步骤协作的高效清洁之道 2025-07-21
-
带你体验通过式喷淋清洗机清洗流程 2025-07-16
-
喷淋清洗机清洗流程解析 2025-07-14
-
高压去毛清洗机去除毛刺的方法解析 2025-07-11
-
喷淋清洗机高压喷嘴流道设计对冲击力的影响 2025-07-10
-
通过式旋转清洗机:中小型零件清洗好帮手 2025-07-09
-
高压去毛刺清洗机:技术特性与应用优势解析 2025-07-08
-
多槽手动超声波清洗机的清洗流程讲解 2025-07-07
-
碳氢清洗机:脱脂战场上的 “附着力守护者” 2025-07-04
-
五轴 CNC 清洗机:攻克盲孔深槽清洁 “最后一公里” 2025-07-03